Table of Contents
Advertisement
Wizard & Main Interface
Click
to edit the searched IP camera as shown on the below left. Input the new IP address,
subnet mask, gateway, username and the password of the camera. You can check "Sync to IPC"
to modify the IP address of the IPC via different network segments for being in the same
network segment with the NVR. Click "OK" to save the settings.
Click
to edit the added camera as shown on the above right. Input the new camera name,
IP address, port, username and the password of the camera. You can click "Test" to test the
effectiveness of the input information. Click "OK" to save the settings. You can change the IP
camera name only when the added camera is online. Click "Next" to continue.
Tips：Please skip Step ⑤ and ⑥ if the NVR do not support RAID function.
⑤ Disk Mode. Click "Enable RAID" to enable the RAID function. Click "Next" to continue.
⑥ Create an array. Set the array name and select array type which including RAID0, RAID1,
RAID5, RAID6 and RAID10. The global hot spares and array capacity can also be set up here.
See 7.5 Disk for details. Click "Next" to continue.
⑦ Disk Settings. You can view the disk number, disk capacity of the NVR and serial number,
R&W status of the disk. Click "Formatting" to format the disk. Click "Next" to continue.
⑧ Record Settings. Two record modes are available: auto and manual.
Auto: Select one auto mode in the interface as shown below and then click the "Next" to save
the settings. Click "Advanced" to self-define record mode. See 7.1.1 Mode Configuration for
details.
20
NVR User Manual
Advertisement
Table of Contents
