Hitachi PC-ARFG-E Installation & Operation Manual page 62

SERVICE & INSTALLATION MENU
Element Optional function
F4 Automatic reset time
Automatic reset temperature
F5
for cooling
Automatic reset temperature
F6
for heating
Prevention of operation
stoppage due to wrong
F7
operation of the remote
controller
Lock function for operation
F8
mode selection
Lock function for temperature
F9
setting
Lock function for fan speed
FA
selection
Lock function for swing louver
Fb
operation
48 PMML0565 rev.1 - 04/2022
Individual
Settings
setting
00 30 minutes (factory setting)
01 15 minutes
X
02 60 minutes
03 90 minutes
19 19°C
20 20°C
21 21°C
· ·
· ·
· ·
24 24°C
X 25 25°C (factory setting)
26 26°C
· ·
· ·
· ·
28 28°C
29 29°C
30 30°C
17 17°C
18 18°C
· ·
· ·
· ·
20 20°C
21 21°C (factory setting)
X
25 25°C
· ·
· ·
· ·
28 28°C
29 29°C
30 30°C
00 Function disabled (factory setting)
X
01 Function enabled
00 Function disabled
X
01 Function enabled (factory setting)
00 Function disabled
X
01 Function enabled (factory setting)
00 Function disabled
X
01 Function enabled (factory setting)
00 Function disabled
X
01 Function enabled (factory setting)
Setting conditions Description
This function sets the automatic
reset time delay for function F3.
This function defines the default
temperature set point for the
automatic reset function F3 in
FAN/COOL/DRY modes.
This function defines the default
temperature set point for the
automatic reset function F3 in
HEAT mode.
Operation is stopped by
pressing the run/stop switch for
3 seconds.
This function is used to prevent
changes to the operation mode.
This function is used to prevent
changes to the temperature
setting.
This function is used to prevent
changes to the fan speed.
This function is used to prevent
changes to the automatic louver
operation.