Advanced Features - Panasonic KX-FT982HK Operating Instructions Manual

Code #13: Setting the dialling mode
DIAL MODE
=TONE [±]
See page 9 for details.
Code #17: Setting the ringer tone
RINGER TONE
=TONE 1 [±]
To set the ringer tone from one of 3 patterns for outside
calls. You can select "TONE 1" (default), "TONE 2" or
"TONE 3".

8.3 Advanced features

See page 28 for how to enter advanced feature
programming.
Code #22: Setting the journal report to print
automatically
AUTO JOURNAL
=ON [±]
"ON" (default): The unit will print a journal report
automatically after every 30 new fax transmissions and
receptions (page 18).
"OFF": The unit will not print a journal report, but will
keep a record of the last 30 fax transmissions and
receptions.
Code #23: Sending documents overseas
OVERSEAS MODE
=ERROR [±]
If you cannot send a fax overseas even if the number is
correct and the line is connected, activate this feature
before sending the fax.
This feature improves the reliability by reducing the
transmission speed.
"ERROR" (default): When the previous fax transmission
fails and you wish to re-send the document.
"NEXT FAX": This setting is effective only for the next
attempted fax transmission. After transmission, the unit
will return to the previous setting.
"OFF": Deactivates this feature.
Note:
L This feature is not available for broadcast
transmission.
L Calling charges may be higher than usual.
Code #25: Sending a fax at a specific time
DELAYED SEND
=OFF [±]
This feature allows you to take advantage of low-cost
calling hours offered by your telephone company. This
feature can be set up to 24 hours in advance of the
desired time.
To send a document:
8. Programmable Features
1. Insert the document.
2. If necessary, press {A} or {B} repeatedly to select
the desired resolution (page 18).
3. Press {MENU}.
4. Press {#} then {2}{5}.
5. Press {A} or {B} repeatedly to select "ON".
6. Press {SET}.
7. Enter the fax number (page 19).
8. Press {SET}.
9. Enter the transmission start time.
L If you select 12-hour time entry when you set the
date and time (page 10), press {*} repeatedly to
select "AM" or "PM".
L If you selected 24-hour time entry when you set
the date and time (page 10), the time is set using
24-hour time entry.
10. Press {SET}.
11. Press {MENU}.
Note:
L To cancel after programming, press {STOP} then
{SET}.
Code #26: Setting the Caller ID list to print
automatically
AUTO CALL. LIST
=OFF [±]
"ON": The Caller ID list will be printed automatically each
time the unit logs 30 different callers (page 15).
"OFF" (default): The Caller ID list will not be printed, but
the unit will keep a record of the information for the last
30 different callers.
Code #31: Activating the Distinctive Ring feature
DISTINCTIVE RING
=OFF [±]
See page 26 for details.
Code #36: Receiving oversized documents
RCV REDUCTION
=ON [±]
To slightly reduce the received fax image when printing,
so that the received document will be approximately the
same length as the original document.
"ON" (default): The received fax image will be printed
slightly smaller than the original image.
"OFF": Deactivates this feature. The received fax image
will be printed at the same size as the original image.
Note:
L A slight margin will be added to the printed
documents, and therefore if this feature is turned
OFF, the received document will be slightly longer
than the original document.
29