Windshield Washer Fluid - Chevrolet 2007 HH7 Owner's Manual

5. Then fill the coolant recovery tank to the
COLD FILL line.
6. Put the cap back on the coolant recovery
tank, but leave the pressure cap off.
7. Start the engine and let it run until you can
feel the upper radiator hose getting hot.
Watch out for the engine cooling fan.
8. By this time, the coolant level inside the
radiator filler port may be lower. If the
level is lower, add more of the proper
®
DEX-COOL coolant mixture through the fill
port until the level reaches the base of
the fill port.
9. Then replace the pressure cap. At any time
during this procedure, if coolant begins to
flow out of the fill port, reinstall the pressure
cap. Be sure the pressure cap is hand-tight
and fully seated.
10. When the engine has cooled, check the
coolant in the coolant recovery tank. The level
in the coolant recovery tank should be at
the COLD FILL line when the engine is cold.
316

Windshield Washer Fluid

What to Use
When you need windshield washer fluid, be sure
to read the manufacturer's instructions before
use. If you will be operating your vehicle in an area
where the temperature may fall below freezing,
use a fluid that has sufficient protection against
freezing.
Adding Washer Fluid
Open the cap with the
washer symbol on it.
Add washer fluid
until the tank is full. See
Engine Compartment
Overview on page 298
for reservoir location.