Turn And Lane-Change Signals; Headlamp High/Low-Beam Changer; Flash-To-Pass - Chevrolet 2007 HH7 Owner's Manual

Turn and Lane-Change Signals

The turn signal has two upward (for right) and
two downward (for left) positions. These positions
allow you to signal a turn or a lane change.
To signal a turn, move the lever all the way up or
down. When the turn is finished, the lever will
return automatically.
To signal a lane change, raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return
by itself when you release it.
As you signal a turn or a lane change, if the arrows
flash rapidly, a signal bulb may be burned out and
other drivers will not see your turn signal. If a bulb is
burned out, replace it to help avoid an accident.
If the arrows do not go on at all when you signal a
turn, check the fuse. See Fuses and Circuit
Breakers on page 381.
156
An arrow on the
instrument panel cluster
will flash in the
direction of the turn or
lane change.

Headlamp High/Low-Beam Changer

To change the headlamps from low beam to high
beam, push the turn signal lever away from you.
To change the headlamps from high beam to low
beam, pull the turn signal lever toward you.

Flash-to-Pass

This feature lets you use your high-beam
headlamps to signal a driver in front of you that
you want to pass.
To use it, pull the turn signal/multifunction lever
toward you until the high-beam headlamps
come on, then release the lever to turn them off.
When the high beams
are on, this light on the
instrument panel
cluster will also be on.