Table of Contents
Advertisement
Level Range
NOTE: Range must be level for satisfactory baking
performance.
1. Place rack in oven.
2. Place level on rack and check levelness of the range - first
side to side, then front to back.
3. If range is not level, adjust the leveling rods. Turn leveling
rods located behind the kick plate to level range and to
raise or lower range to the desired countertop height.
NOTE: All roller feet must be off the floor upon final installation.
A. Rear leveling rod
B. Front and brass leveling rod
Install Grill Grease Trays (on grill models)
1. Remove flame spreader. Pull forward slightly on the flame
spreader to release the tabs from the rear slots and lift out.
A. Grill front
B. Rear tabs and slots
2. Cut and remove tie strap from rear of burner assembly.
A
A. Tie strap
18
A
B
A
B
B
A
3. Lift burner assembly up and out to remove.
4. Slide drip tray into opening on the right front side of the grill
basin. There are guides to assure correct placement of the
drip tray.
A. Drip tray
5. Insert the large grease tray all the way under the back edge
of the grill basin and hook it into the slots.
A
A. Large grease tray
B. Slots
6. Insert the small grease tray all the way under the front
of the grill basin and hook it into the slots.
When the 2 grease trays are installed properly, the small
grease tray will hook over the large grease tray.
A
B
C
A. Large grease tray
B. Grease tray connection
C. Small grease tray
D. Slots
7. Insert the orifice tube on the front of the burner assembly
into the opening at the front of the grill basin and set burner
assembly into place.
A
A. Front opening
A
B
D
Advertisement
Table of Contents
