Table of Contents
Advertisement
Program mode
Page Select
For details on how to select each page, refer to the "M3
operation guide."
Page
Select and play RADIAS programs.
Simple KARMA editing.
Audio input settings and resampling
P0: Play
settings.
Editing from the control surface.
(☞M3 PG p.2)
Basic RADIAS program settings, such as voice
assign mode.
Drum track settings.
P1: Basic/DT/Ctrls
X–Y control settings.
SW1, 2, and slider function settings.
Pad note and velocity settings.
(☞p.25, ☞M3 PG p.25)
Oscillator selection and pitch settings.
P2: OSC/Pitch
(☞p.30)
P3: Filter
Filter (tone) settings. (☞p.34)
Amp (volume) settings.
Drive/Wave shape settings.
P4: Amp/EQ
3-band parametric EQ settings.
(☞p.36, ☞M3 PG p.58)
EG settings.
LFO settings.
P5: EG,/LFO/M SEQ
Modulation Sequencer settings.
(☞p.38)
P6: Vocoder
Vocoder settings. (☞p.42)
P7–1: KARMA1
Overall settings for KARMA, and settings for
GE Setup/Module
each module. (☞M3 PG p.77)
KARMA realtime parameter settings and
P7–2: KARMA2
performance parameter settings.
GE RTP/Perf
(☞M3 PG p.90)
Oscillator output bus and master effect send
level settings.
P8: IFX
Insert effect routing, selection, and settings.
(☞M3 PG p.98)
Master effect routing, selection, and settings.
P9: MFX/TFX
Total effect selection and settings.
(☞M3 PG p.103)
Parameter guide
Main content
PROG P0: Play
In this page you can select and play programs. Here you can
also perform simple editing of the drum track, EQ, and
KARMA function, make settings for the audio inputs and
resampling, and view the control surface.
0–1: Main
Here you can select a program and specify the tempo. You
can also specify the drum track pattern, program, and EQ.
These settings are linked with the parameters shown in P1–
3, 4, and P4–8.
The screen shows the settings for SW1, SW2, the control
surface, the filters, and EG2 (amp).
For details on the available parameters and menu
commands, refer to the "M3 parameter guide."
0–5: KARMA GE
Here you can adjust the parameter settings for the KARMA
function in Program mode. A RADIAS program can use one
KARMA module (module [A]).
For details on the available parameters and menu
commands, please see "0–5: KARMA GE" on page 4 of the
M3 parameter guide.
0–6: KARMA RTC
Here you can view the names of the KARMA CONTROLS
sliders and KARMA Switch 1–8, and the values that are
written to the parameters. The number and value of the GE
realtime parameters and performance realtime parameters
controlled when you operate these controllers is also shown.
For details on the available parameters and menu
commands, please see "0–6: KARMA RTC" on page 6 of the
M3 parameter guide.
19
Advertisement
Table of Contents
