Table of Contents
Advertisement
Installation
1
1
Check up the installation site.
● Do not install the washing machine at the
following location:
– Near a heat source (gas stove, water heater, etc.)
→ At least 1.5 meters away.
●
Near heaters (including above, in front of, and
beside them). Do not stack combustibles.
– Location with water or high humidity (e.g. bathroom)
– Location exposed to wind, rain or direct sunlight (e.g.
terrace)
– Location with temperatures close to freezing point
– Location with uneven or unstable floor
– Location with slippery floor, e.g. tiled ground
● Keep a clearance of at least 10 cm between the
washing machine and wall to keep noise down.
● Do not block the opening on the bottom with an
object, such as a carpet.
2
Install the water drain hose.
Install the end of the water drain hose at a height of
0.7 m to 1.1 m.
● Install so that the end of the water drain hose will
not be soaked in water.
Connect the water supply hoses to
3
the washing machine.
Press the end of the supplied water
supply hose (blue line) with an elbow
straight against the water supply valve
4
3
2
6
5
Max. 1.1 m
Mín. 0.7 m
screw on the back of the washing
machine indicated as "COLD", and tighten
the nut clockwise with your hand.
Water supply valve screw
Water supply
hose (COLD)
Likewise, connect the supplied water
supply hose (red line) to the water supply
valve screw on the back of the washing
machine indicated as "HOT".
● Check whether or not the elbows are unsteady
or loose.
Connect the water supply hoses to
4
water faucets.
Press the other end of the water supply
hose connected to the washing machine
straight against the cold water faucet, and
tighten the nut clockwise with your hand.
Likewise, connect the other end of the
water supply hose (white) connected to
the washing machine to the hot water
faucet.
● Turn on the water faucets to check that water
leaks from neither the water supply valves of the
washing machine nor the water faucets.
Nut
Nut
Water supply
hose (HOT)
Elbow
23
Advertisement
Table of Contents
