HIKVISION DS-2DE3304W-DE User Manual page 91

User Manual of Network Mini PTZ Camera
4. Draw area.
(1) Select the Line No.in dropdown list.
(2) Click
(3) Click the line to switch to the editing mode.
Click and drag an end to the desired place to adjust the length and angle of
the plane. And click and on the line to adjust the location.
Up to 4 lines are supported.
5. Configure the parameters for each defense region separately.
 Direction: Select the detection direction in the dropdown list, there are A<->B,
A->B and B->A selectable.
 Sensitivity: Range [1-100]. The value of the sensitivity defines the size of the
object which can trigger the alarm, when the sensitivity is high, a very small
object can trigger the alarm.
6. Click to edit the arming schedule for line crossing detection. The
arming schedule configuration is the same as the setting of the arming schedule
for motion detection. Refer to Step 2 in Section 7.6.1 Configuring Motion
© Hikvision
Figure 7-50 Configuring Line
to draw a plane on the image.
90