Operation; Start-Up And Initial Setting; Welcome; Network Setting - ViewSonic CDE5010 User Manual

4.

Operation

NOTE: The control button described in this section
is mainly on the remote control unless
specified otherwise.
4.1.

Start-up and initial Setting

4.1.1. Welcome

Select your language and tap "Start".

4.1.2. Network Setting

Tape "Next" button to next page and it will show.
1. Connection Type : DHCP / Static IP
2. IP Address
3. Netmask
4. DNS Address
5. Gateway
You also can tape "Skip" to configure later

4.1.3. Signage Display Settings

User can import the setting file from SD, USB or
manual setting. User also can tape "Skip".
Note: The setting file should be put on viewsonic
folder in SD or USB and the file name is settings.
db.

4.1.4. Setup Complete

The initial settings are completed. Press "Finish"
and display will reboot automatically.
4.2.

Watch the Connected Video Source

1. Press SOURCE
2. Press or button to select a device, then
press OK button.
4.3.

Change Picture Format

You can change the picture format to suit the video
source. Each video source has its available picture
formats.
The available picture formats depend on the video
source:
1. Press FORMAT button to choose a picture
format.
• PC mode: {Full} / {4:3} / {Real} / {21:9}/
{Custom}.
• Video mode: {Full} / {4:3} / {Real} / {21:9}/
{Custom}
12
button.