Storage; Returning To Service - Coleman CT200U-EX V Owner's Manual

Storage

If the Mini Bike is left unused for an
extended period of time, proper storage
maintenance is required.
1. Wash Mini Bike thoroughly, then wax
painted parts with a non abrasive auto
wax. Coat vinyl seat and rubber parts
with a vinyl/rubber protectant.
Note: Keep water away from air intake
and muffler outlet while washing to
avoid water from entering the engine
and/or components.
2. Drain carburetor by placing fuel
valve (1) to the off (right) position and
opening the drain screw (2). Allow all
fuel to drain from the carburetor. Once
fuel is drained, re-tighten drain screw
(2). Note: Make sure to drain fuel in a
proper storage container.
3. Fill fuel tank to full with gasoline
mixed with fuel stabilizer as
recommended by the fuel stabilizer
manufacture. Note: Fuel stabilizer
can be purchased at most motorcycle
shops and auto parts stores.
4. Remove spark plug and poor 1
tablespoon of motor oil in the spark
plug hole. Re-install spark plug.
5. Place the starter button to the off
position and pull the start recoil cord
a few times. This is to coat the inside
cylinder head with oil.
6. Fill tires with correct air pressure.
7. If possible, store Mini Bike in a shed
or garage with a cover to protect from
dust, dirt and humidity. If the Mini
Bike must be stored outdoors, cover
completely with a good waterproof
cover.

Returning to service

1. Wash Mini Bike thoroughly.
Note: Keep water away from air
intake and muffler outlet while
washing to avoid water from
entering the engine and/or
components.
2. Drain engine oil and replace
with fresh clean oil as listed in this
manual.
3. Review this owner's manual
and follow the pre-ride inspection
procedures.
4. Start engine by following the
starting procedures in this manual.
26
1
2