Configuring The Starting Address; Dmx Operation; Master/Slave (Standalone Operating Modes) - Chauvet 38 User Manual

Configuring the Starting Address

DMX Operation

Master/Slave (Standalone Operating Modes)

Although any fixture in the DMX daisy chain may be set to master, it is advisable to set the
master as the first fixture in the line.
Do not connect a DMX controller to the daisy chain for this operating mode.
4. Operating Instructions
Each fixture requires a starting address from 1~512. A fixture requiring one or more channels for
control begins to read the data on the channel indicated by the starting address. For example, a
fixture that uses seven DMX channels and is addressed to start on DMX channel 100, will read
data from channels: 100, 101, 102, 103, 104, 105 and 106. Choose the starting addresses for
each fixture so that the channels used do not overlap. In addition, you should note the starting
address selected for future reference.
The SlimPAR™ 38 uses seven or three DMX channels. If this is your first time using DMX, we
recommend reading the "DMX Primer" section in the "Appendix".
This is the operating mode which will allow for control with an external DMX controller. You must
set the starting address for this mode. If this is your first time using DMX, then it is recommended
that you refer to the "DMX Primer" section in the "Appendix" of this manual.
1. Press <MENU> until
2. Press <ENTER>.
3. Using <UP> and <DOWN>, select the desired DMX address (
This is the operating mode which will allow one fixture to act as the "master" and control all of the
other "slave" fixtures. You must set both the master and the slave(s) fixtures to the correct mode
for this operation.
Master Settings:
1. Connect the fixtures with DMX cables, as shown in the "Fixture Linking" section.
2. Use any one of the standalone modes for the master unit.
This includes: ,
Slave Settings:
1. Press <MENU> until
2. Press <ENTER>.
3. Using <UP> and <DOWN>, set the DMX address to
4. Press <ENTER>.
Only one fixture may be set to master.
It does not matter which DMX mode is selected for the slave fixtures. Either mode will be
effective.
or appears on the LED screen.
, and
or appears on the LED screen.
10
~ ).
.
7/20/2010 5:31 PM