Operation - Greenlee CSJ-100 Instruction Manual

Operation

1. Set the selector switch according to the Settings Table.
2. Refer to "Typical Measurements" for specific measurement
instructions.
3. Test the unit on a known functioning circuit or component.
• If the unit does not function as expected on a known functioning
circuit, replace the battery.
• If the unit still does not function as expected, send the unit to
Greenlee for repair. Refer to the instructions under the Warranty.
4. Take the reading from the circuit or component to be tested.
Settings Table
To measure
this value ...
AC Voltage
DC Voltage
Resistance
AC Current*
To measure
this value ...
Diode
Continuity
* AC current measurements are made using the jaw. Refer to "Typical
Measurements" for specific measurement instructions.
8
Electric shock hazard:
Contact with live circuits could result in severe
injury or death.
Set the
Selector
Switch
to this This icon appears
symbol ... on the display ...
Momentarily press
Set the
Selector
Switch
to this
symbol ... on the display ...
the Hold/Toggle
Button until this
icon appears
Connect Connect
red black
lead lead
to ... to ...
V-Ω COM
V-Ω COM
V-Ω COM
N/A N/A
Connect Connect
red black
lead lead
to ... to ...
V-Ω COM
V-Ω COM