Transportation And Setup - Greenlee 854 Instruction Manual

Transportation and Setup

Hoisting the Bender
To hoist the bender, use either slings (nylon or polyester)
or chains with hooks. Each side of the sling or chain
must be at least 915 mm (36") long to prevent contact
with the bender. All lifting components must be rated for
231 kg (510 lb).
1. Pivot the bending head to the horizontal position
with the 1-1/2" to 2" shoe upward (see Pivoting the
Bender Head in this section of the manual).
2. Rotate the lifting eyes so they are accessible.
3. Loop the slings through, or attach the hooks to, the
lifting eyes.
4. Hoist the bender.
Greenlee / A Textron Company
Pivoting the Bender Head
The bender head has two bending positions — vertical
and horizontal. To change the bender head position:
1. Pull out the bender head pivot lock knob. It may be
necessary to twist the knob clockwise until the pin
clears the frame.
2. Pivot the bending head to the desired bending
position.
3. Push the bender head pivot lock knob back into
position so that the pin is fully engaged in the hole.
4. Twist the pivot lock knob counterclockwise until you
feel some resistance. Do not tighten it.
7
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
854 Quad Bender