Grounding Instructions; Setup - Greenlee 855 Service Manual

Grounding Instructions
Electric shock hazard:
• Do not modify the plug provided
with the tool.
• Connect this tool to a grounded
receptacle on a 20 A GFCI-pro-
tected circuit.
Failure to observe these warnings
could result in severe injury or death.
This tool must be grounded. In the event of a malfunc-
tion or breakdown, an electrical ground provides a path
of least resistance for the electric current. This path of
least resistance is intended to reduce the risk of electric
shock.
This tool's electric cord has a grounding conductor and
a grounding plug as shown. Do not modify the plug.
Connect the plug to a corresponding GFCI-protected
receptacle that is properly installed and grounded
in accordance with all national and local codes and
ordinances.
Do not use an adapter.
NEMA L5-20
Plug
Greenlee / A Textron Company

Setup

Follow these steps, which are described in greater detail
in this section, to set up the bender.
1. Transport the bender to the job site.
2. Lower at least two jackscrews or use the optional
3. Pivot the bending head to the desired position.
4. Connect the pendant to the bending head.
5. Plug the power cord into a 120 VAC, 20 A GFCI-
6. Turn on the power switch.
Transporting the Bender
Make sure that all components used to lift the bender
are properly rated for the 231 kg (510 lb) weight. Use
a ramp to load and unload the bender from a truck or
other vehicle that is not equipped with a lift gate.
To roll the bender:
1. Raise the jackscrews so that they clear the job site
2. Pivot the bending head to the horizontal position
3. Use the transport handle to push and steer the bender.
To lift the bender:
Receptacle 1. Pivot the bending head to the
2. Rotate the lifting
3. Loop the sling (or
4. Securely attach the
5
855 Smart Bender
Wear eye protection when operating
or servicing this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris.
kickstand to prevent the unit from rolling.
protected receptacle. For best performance, use a
dedicated circuit for this unit and do not use exten-
sion cords.
terrain.
with the 1-1/2" to 2" shoe facing up.
horizontal position with the
1-1/2" to 2" shoe facing up.
eyes so that they
are accessible.
attach the hooks)
to the lifting
eyes. Make sure
that each side of
the sling or chain
is 1 m (3') long
to prevent it from
rubbing against
the bender.
sling or chain to the
lifting device.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
®