Advertisement
3000 Lbs. Capacity Vehicle Lift
Instructions for Part # CARLIFT-3000
GENERAL GUIDELINES & SAFETY
• It is the user's responsibility to read and follow all instructions.
• Keep these instructions with the product at all times and review before each use.
• It is the responsibility of this product's owner to furnish the instructions to any person that borrows
or purchases the product.
• Inspect the product before use to ensure it is assembled properly and all parts are in safe working
order and free of defects.
• Never modify this product in any way.
• All circumstances cannot be addressed in these instructions.
Please use common sense and practice general safety measures when using this product.
• Parts and/or instructions are subject to change without notice.
• Do not exceed the 1,500 lb. per ramp capacity, or 3,000 lb. per axle capacity.
• Keep children and unauthorized persons away from the work area.
• Wear ANSI approved safety goggles when operating the lift.
• Before using, lubricate the screw and the nuts with grease to reduce friction.
• Always keep your hands and feet away from the working area.
• Do not allow untrained persons to operate the lift.
• Do not expose the lift to rain or snow.
• Ensure you read, understand, and apply the safety instructions and warnings before use.
• Failure to follow these instructions may result in property damage and/or personal injury.
070621
1-888-651-3431
Page 1
Advertisement
Table of Contents
Related Manuals for Black Widow CARLIFT-3000
Summary of Contents for Black Widow CARLIFT-3000
- Page 1 3000 Lbs. Capacity Vehicle Lift Instructions for Part # CARLIFT-3000 GENERAL GUIDELINES & SAFETY • It is the user’s responsibility to read and follow all instructions. • Keep these instructions with the product at all times and review before each use.
- Page 2 INSTRUCTIONS STEP 1: Align ramps with both hoses facing each other, place the foot pump between them STEP 2: Remove red caps from hoses and connect to hydraulic pump. STEP 3: Place ramps in front of tires. Slowly drive vehicle onto ramps. Page 2 070621 1-888-651-3431...
- Page 3 STEP 4: Use foot pump to raise ramps. Flip the safety plate into position using the Safety Plate Tool. DO NOT USE YOUR HANDS. STEP 5: To lower the ramps, slowly loosen the release knobs simultaneously, to maintain a consistent speed. NOTE: KEEP ALL BODY PARTS CLEAR! Page 3 070621...
- Page 4 PRODUCT WARRANTY & LIABILITY GENERAL PRODUCT WARRANTY: Products purchased from the Authorized Dealer (original place of purchase) or Merchant (“Dealer”) will be free of defects in material and workmanship at the time of receipt, and will meet the specifications stated at the place of purchase transaction or online at the Dealer’s website, under normal use and service when correctly installed, operated and maintained.
Need help?
Do you have a question about the CARLIFT-3000 and is the answer not in the manual?
Questions and answers
with a car on the lift and fully extended can you disconnect the hoses on the pump
No, the hoses should not be disconnected while the Black Widow CARLIFT-3000 is fully extended and holding a car. Disconnecting the hoses could cause the lift to lose hydraulic pressure and fail, leading to possible injury or property damage.
This answer is automatically generated