Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Vintec V20SGEBK
Summary of Contents for Vintec V20SGEBK
- Page 1 User Manual V20SGEBK vintec.com...
- Page 2 Vintec manufacturer’s warranty provided with your product. Products must be used, installed and operated in accordance with this manual. You may not be able to claim on the Vintec manufacturer’s warranty in the event that your product fault is due to failure to adhere this manual.
- Page 3 The information in this document is subject to modification without any prior notice. VINTEC offers no guarantee for our wine cellar if it is being used for any purpose other than that for which it was specifically designed. VINTEC cannot be held responsible for any error in this manual.
- Page 4 Placing your unit in extreme cold or hot conditions may cause interior temperatures to fluctuate. The ideal range of temperature may not be reached. (See Climate Class at the end of this manual) User Manual V20SGEBK...
- Page 5 Leveling your wine cellar: Wine cellar must be leveled BEFORE loading your wines. Your wine cellar is equipped with 4 adjustable feet to facilitate easy leveling. VINTEC recommends that you tighten the back feet to the maximum and adjust the front feet to create a level.
- Page 6 Back spacer: Compressor-run appliances require proper ventilation for proper and longer usage. Your Vintec wine cellar is supplied with a back spacer. Affixed the back spacer at the back of the cellar for air circulation and heat evacuation. IMPORTANT - THIS SPACER MUST BE ATTACHED TO THE UNIT BEFORE INSTALLATION FOR VENTILATION PURPOSE.
- Page 7 An individual’s perception of noise is directly linked to the environment in which the wine cellar is located, as well the specific type of models. VINTEC wine cellars are in line with international standards for such appliance. VINTEC will always do its utmost to satisfy its customers but will not retake possession of the goods due to complaints based on normal operating noise occurrences.
-
Page 8: Temperature Settings
1 degree Celsius. The temperature setting can be adjusted from 5℃ to 18℃ To visualize the “set” temperature, press and hold the UP or DOWN buttons, the “set” temperature will temporarily “flash” in the LED display for 5 seconds. User Manual V20SGEBK... -
Page 9: Wine Serving Temperature Chart
Room temperature not exceeding 20ºC IMPORTANT INFORMATION ABOUT TEMPERATURE Your VINTEC wine cellar has been designed to guarantee optimum conditions for storing and/or serving your wines. Fine wines require long and gentle developments and need specific conditions in which to reach their full potential. - Page 10 For easy access to the storage content, you must pull the shelves approximately 1/3 of its depth out of the rail compartment. This unit is, however, designed with a notch on each side of the shelf tracks to prevent bottles from falling. User Manual V20SGEBK...
- Page 11 • When removing any of these shelves out of the rail compartment, To fit or remove the shelf, tilt the shelf as per the diagram and simply pull out, or push in the shelf until it sits on the support brackets securely. User Manual V20SGEBK...
- Page 12 Dimension and Installation Guide 20 Bottle Single Zone Wine Cabinet V20SGEBK Drawings for built-in purposes Spacer FRONT VIEW SIDE VIEW Spacer NOTE: Illustrations not to scale. All dimensions in millimetres. * Minimum 10mm required whether proud-fit or flush-fit, however 30mm is recommended on the opening edge for easy finger grip access when installed flush-fit.
-
Page 13: Operation Anomalies
Check fuse, if any. Make sure that the door is closed properly. If your wine cellar appears to be malfunctioning, unplug it and contact your VINTEC’s after sales service. Any intervention on the cold circuit should be performed by a refrigeration technician who should carry out an inspection of the circuit sealed system. -
Page 14: Troubleshooting Guide
The Wine cellar is not level. The Wine cellar is not level. The door will not close properly. The door was reversed and not properly installed. The gasket is faulty. ( magnet or rubber is spoiled) The shelves are out of position. User Manual V20SGEBK... -
Page 15: Warranty
(c) ‘ASC’ means Electrolux’s authorised serviced centres; (viii) insect or vermin infestation; (d) ‘Vintec/Transtherm’ is the brand controlled by Electrolux Home Products (ix) failure to comply with any additional instructions supplied with Pty Ltd of 163 O’Riordan Street, Mascot NSW 2020, ABN 51 004 the Appliance;... -
Page 16: Service And Support
Service and support In the rare event that your Vintec cabinet does not perform to your satisfaction, contact our dedicated support team: 1800 771 776 concierge@vintecclub.com Vintec. We are part of the Electrolux Family. To add a touch of professional inspiration to your home, visit electrolux.com.au...