Ranger design 1525-PC Installation Manual page 13

1.2.9 Loosen the pre-assembled hardware on the ladder clamp hasps, slide the hasps on the skis to the
position shown below, and tighten the nuts.
1.2.10 Slide 3pcs. of carriage bolts on the rear end of the each ski, then attach end plugs on
both ends of the skis.
For technical support, contact us at 1-800-565-5321
end plug
end plug
TOOLS
q Cordless Impact
q 1/2" Socket
q Tape Measure
q Marker
HARDWARE USED
4×
-
hardware is pre assembled
#90-487 Carriage Bolt 5/16" × 3/4"
#98-117 Flat Washer
#98-123 Lock Washer
#94-105 Hex Nut
end plug
TOOLS
q Mallet
HARDWARE USED
6×
#90-491 Carriage Bolt
5/16" × 1" SS304
1525-PC Installation Guide | REV. B2 | Page 13
.