Intex PureSpa SB-HW10 Owner's Manual page 12

Spa Control Unit Installation
Connect the spa control unit to the spa tub (see drawing 10). Hand-tighten the connectors securely. Do not
1.
use tools to tighten.
NOTE: Never attach external accessories not supplied with the kit to the spa tub or control base unit, as
this will void the warranty.
Replace the control base side covers (4) (see drawing 11).
2.
CAUTION: Do not sit, lean, cover or place any objects over the spa control unit.
Attach the two fi lter cartridge housing assemblies to the two outlet
3.
grids on the inside of the spa (lower position, marked "C"). Infl ate
the spa tub fi rst before installing fi lter pump fi ttings.
ATTENTION! In order to comply with the requirements of the
Virginia Grahame Baker Act, suction outlets cannot be covered
while the spa is in use. The Act was intended to address high
suction/volume circulation systems but does not exclude low
volume systems as used on this spa. Accordingly, remove the fi lter
cartridge assemblies and any other spa cleaning attachment from
the spa outlets before spa usage (see drawing 12).
Re-attach them after usage for water fi ltration and cleaning.
Before fi lling with water ensure the bottom drain valve caps are
4.
securely closed on the inside and outside.
Fill the spa tub with freshwater to a level between MIN and MAX
5.
marked on the inside of the spa wall. Do not over fi ll the spa.
Never move the spa tub with water inside and/or with the control
base attached to the spa as the spa or control base may be damaged.
WARNING: Never pour water with a temperature higher than
104°F(40°C) into the spa directly. It is recommended to fi ll the spa tub with lukewarm water for quick
heating and energy saving.
Place the spa cover and spa air bladder (pre-installed in spa cover)
6.
over the spa tub, and make sure the spa cover buckles are locked using the key provided after pulling the
buckled straps tight.
IMPORTANT: Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
Ensure the spa is plugged into a electrical socket and press the
7.
buttons fi rst. Press the
operation section.
S AVE THESE INSTRUCTIONS
(346PO) SPA ENGLISH 7.5" X 10.3" PANTONE 295U 08/10/2019
SET UP (continued)
10
button on the control panel to activate the heater, see "Spa Control Panel"
English
C
button to turn on the control panel
Page 12
346
PO
11
12