Toshiba Strata DKT3010F-S User Manual page 45

Call Forward
Station Call Forward Procedures
The following table contains Call Forward Button sequences. You can do a Call Forward function by,
one, entering the button sequence as described, or two, by programming a Flexible Button to perform
the sequence. See
Flexible Button.
Some Call Forward features require a Pass Code entry. Use the following procedure to change your
Pass Code.
To change your Pass Code
Press Extension button +
(1~15 digits) +
To use the Call Forward button sequence
Follow the instructions in the following table, shown under "Button Sequence." Some features
require additional input, such as:
Destination – If the destination is an outside number, press
The CTX accepts destination numbers of up to 32 digits.
Timer – This is a two digit entry representing how long (eight to 60 seconds) your telephone
should ring before forwarding the call. If you enter one digit, you must press
the single digit.
Pass Code – A four-digit code established by system programming to prevent unauthorised
changes. The code applies to the station to be forwarded; not to the station entering the code.
In the following table, (Tone) means that a confirmation tone will play at that point in the
Note
sequence.
32
"Programming Feature Buttons" on page 67
#670 + ext. no. + old Pass Code (1~15 digits) +
# .
for instructions on programming a
Strata CTX DKT3000/2000-Series Digital Telephone October 2002
Advanced Operation
# + new Pass Code
after entering the destination.
#
after entering
#