Omron ZG2-WDS8T User Manual page 8

Observe the following precautions to prevent failure to operate, malfunctions, or
undesirable effects on product performance.
1. Installation Site
Do not install this product in locations subjected to the following conditions:
• Ambient temperature outside the rating
• Rapid temperature fluctuations (causing condensation)
• Relative humidity outside the range of 35 to 85%
• Presence of corrosive or flammable gases
• Presence of dust, salt, or iron particles
• Direct vibration or shock
• Reflection of intense light (such as other laser beams or electric arc-welding
machines)
• Direct sunlight or near heaters
• Water, oil, or chemical fumes or spray
• Strong magnetic or electric field
2. Power Supply and Wiring
• When using a commercially available switching regulator, make sure that the FG
terminal is grounded.
• If surge currents are present in the power lines, connect surge absorbers that suit the
operating environment.
• Before turning ON the power after the product is connected, make sure that the power
supply voltage is correct, there are no incorrect connections (e.g. load short-circuit),
and the load current is appropriate. Incorrect wiring may result in breakdown of the
product.
• Before connecting/disconnecting devices, make sure that the devices are turned OFF.
The devices may break down if it is connected/disconnected while the power is ON.
• Use only combinations of the Sensor Controller specified in this manual.
3.Maintenance and Inspection
Do not use thinner, benzene, acetone or kerosene to clean the Data Storage Unit.
4.Compatibility of Mesurement Data
This product is the dedicated data storage unit for ZG2 series.
Data cannot be logged when existing ZG series products are connected to the Data
Storage Unit.
Bank data or System data saved using ZG series cannot be processed with this product.
6
Precautions for Correct Use
ZG2-DSU User's Manual