Sensor Options For Plasma Power Sources; Setup - Bug-O Systems AVC-2060 Instructions And Parts Manual

SENSOR OPTIONS FOR PLASMA POWER SOURCES

Manufacturer
ESAB Cutmaster 82 with full-
®1
featured automation
interface PCB option
Hypertherm Powermax45 XP
®2
CPC port and voltage
divider
Hypertherm Powermax65
®
CPC port and voltage
divider
Hypertherm Powermax85
®
CPC port and voltage
divider
Hypertherm Powermax105
®
CPC port and voltage
divider
Hypertherm Powermax125
®
CPC port and voltage
divider
Hypertherm Powermax1650
®
Lincoln Tomahawk1538
Electric
®3

SETUP

AVC-2060 Plasma Height Control
This is available as original equipment or as a retrofit unit designed to provide Plasma Height Control
on BUG-O Modular Drive Systems (MDS) with the Pendulum Weaver (WPD-2100).
CAS-1500-18 Height Slide Assembly
This replaces the Gun Mounting Group originally supplied on the Pendulum Weaver. To install, begin
by remove the WPD-2050 Gun Mounting Group from the weaver, [Refer to Modular Drive System
Instructions and Parts Manual]. Install Pendulum Weaver Adapter CAS-1558. Slide clamp on bottom of
Height Slide Assembly CAS-1500-18 onto the CAS-1558 and lock in position.
6
AVC
Model Sensor
Option
-ID
with -ID
®
with -ID
®
with -ID
®
with -ID
®
with -ID
®
®
-RV
®
-RV
CAS-1558 Pendulum Weaver Adaptor
AVC
On/Auto
Additional Connection Instructions
Switch
Position
Auto Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Auto Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Auto Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Auto Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Auto Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Auto Contactor wires plug into AVC-1550, which
sends them to the plasma source.
Auto AVC-1002 will need to be installed and will
need to connect to J15 and J16. Contactor
wires will need to be connected to the AVC-
1550 and then AVC-1003 (sold separately) can
connect the AVC-1550 to the machine inter-
face connection for arc start and arc transfer.
AVC-1002 will need to be installed and will
On
need to connect to the EL2 and OUT1. Con-
tactor wires will need to connect to the Toma-
hawk's accessory connector. A competent
person must determine how to best make
these connections.