Care And Maintenance - Sharp FP-F40A Operation Manual

CARE AND MAINTENANCE

To maintain optimum performance of this air purifier, please clean the unit including the filter
periodically.
Be sure to disconnect the power cord from the wall outlet before performing any maintenance.
BACK PANEL
Back Panel
NOTE
Back Panel
FILTERS
HEPA Filter
Tag
Active Carbon Deodorizing Filter
SENSOR
Dust sensor filter
OM_FP-F40A_EN.indd 8
(Pre-filter)
Gently remove dust from the back panel by using
a vacuum cleaner attachment or similar tool.
CAUTION
Do not apply excessive pressure when scrubbing
the back panel.
How to clean stubborn dirt
1. Add a small amount of kitchen detergent to water and soak
for about 10 minutes.
2. Rinse off the kitchen detergent with clean water.
3. Completely dry the filter in a well-ventilated area.
Gently remove dust from HEPA Filter and Active Carbon Deodorizing
Filter with a vacuum cleaner attachment or similar tool.
CAUTION
Do not WASH in water and DRY in the sun.
The filters are fragile, be careful not to apply too much force.
• HEPA Filter
Apply the maintenance only on the side with the tag.
Do not clean the opposite side; otherwise, the filter will be
damaged.
• Active Carbon Deodorizing Filter
The maintenance can be applied to the both sides.
1. Remove the Back Panel.
2. Remove the Dust Sensor Filter.
3. If it is very dirty, wash it with water and dry it
thoroughly.
E-8
2015/10/20 8:47:32