Table of Contents
Advertisement
3. S
ETUP
AC Power
This product runs on 100~240 VAC, 50/60 Hz. Before powering on the unit, make sure the line
voltage to which you are connecting it is within the range of accepted voltages.
Always connect the product to a switched circuit. Never connect the product to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as
a 0 to 100% switch.
To determine the power requirements for a particular product, see the label affixed to the back
plate of the product or refer to the product's specifications chart. A product's listed current rating
indicates its average current draw under normal conditions.
Always connect the product to a circuit with a suitable electrical ground.
Power Linking
This product contains power linking via the Edison outlet located in front of the power input cable.
Please see the diagram below for further explanation.
The maximum number of products that may be linked for this product is 20.
Product #3
Product #2
Product #1
The power linking diagram shown above corresponds to the North American version
of this product ONLY! If using this product in other markets, you must consult with
the local CHAUVET® distributor, as power linking connectors and requirements may
differ in your country or region.
Scorpion™ GBC User Manual
Additional
power link
11
August 2011
Advertisement
Table of Contents
