Pre-Installation Checks; Checking The Installation Environment; Checking The Appliance, Accessories, And Items Required For Installation - Mitsubishi Electric Jet Towel JT-SB216JSH2-S-NE Installation Manual

Pre-installation checks

■ Checking the installation environment

Do not install in the following types of location.
(This may cause malfunctions.)
Outdoors Locations where the temperature could be lower than 0ºC.
Locations where the temperature could be higher than 40ºC
Locations where salt damage could occur
Locations where corrosive, neutral, or reductive gases are present
Near food or tableware
(Where there is a risk of water splashing)
Locations where the appliance is direct sunlight or strong light.
(May cause the sensor to malfunction)
Rooms that have a sterilization basin, swimming pools, bathrooms.
■ Check the appliance, accessories, and items required for installation
Product
Main unit
Required items
Screwdriver
Longer than 150mm
■ Prepare if required
Single wire for internal wiring
(Cable core: between 2.0mm
2
and 3.0mm )
※ Not needed if the
internal wiring is
complete
■ Check the heater settings and air speed settings. (Heater settings only for JSH2)
Check the heater ON/OFF settings and air speed HIGH/STANDARD settings with the customer beforehand.
(The customer cannot adjust the settings after installation is complete.)
Vehicles (including ships and airplanes)
Kitchens Locations where the appliance may come into direct contact with water
Drain tank
Air fi lter
Pen
To mark position to insert metal
screw plugs in the wall
2
SCREW ANCHOR...6
※ Use on concrete walls
− 3 −
Locations where there is a lot of dust
Locations where there is a lot of condensation
Accessories
Mounting screws (5 x 30 Type 1 tapping screws)... 6
Installation panel...1
Cord clip ...1
Clip mounting screw...1
Wall reinforcement
※ Reinforces walls made
of materials other than
concrete