Table of Contents
Advertisement
Recording
Renaming Recorded Data
Here's how to change the name of recorded data.
1
In the SONG screen (p. 14), press the [F3] (REC DATA)
button.
2
Turn the [R1] knob to select recorded data.
3
Press the PAGE [DOWN] button.
4
Press the [F4] (NAME) button.
The SONG NAME screen appears.
5
Edit the name (p. 25).
You can enter up to 16 characters as the song name.
6
Press the [F5] (EXIT) button to exit the SONG NAME
screen.
Exporting Recorded Data to an SD Card
(SONG EXPORT)
Data that you recorded in internal memory or on an SD card can be
exported to an SD card as an audio file (WAV) or SMF data.
1
In the SONG screen (p. 14), press the [F3] (REC DATA)
button.
2
Turn the [R1] knob to select the type of export.
3
Press the [F4] (EXPORT) button.
The SONG EXPORT screen appears.
4
Turn the [R1] knob to select the type of export.
Display
Explanation
SMF (DRUM ONLY)
Export the drum performance as SMF.
Export the sound of the drum performance as an
WAV (DRUM ONLY)
audio file.
Export the sound of the drum performance and
the song as an audio file.
WAV (DRUM+SONG)
* You can't select this for recorded data that was
If you recorded as "DRUM only"
The drum performance is exported as an audio
file and as SMF.
If you recorded as "with SONG"
ALL (WAV+SMF)
Drum performance sounds are exported as an
audio file and as SMF, and the drum performance
sounds and the sound of the song are exported as
an audio file.
MEMO
You can press the [F4] (NAME) button and assign a name for the
exported file.
18
recorded as "DRUM only. "
5
Turn knobs [R2] or [R3] to specify the export settings (only
if exporting an audio file).
Parameter
Explanation
By pressing the [ s ] button you can preview-play the
recorded data that is produced by the export. While
watching the output level meter, adjust the volume of
the audio file. Positive (+) values increase the volume.
Export Gain
In some cases, the reverberation of the last notes might
be cut off in the exported audio file. If so, you can
Post Export Time
increase this value to prevent the reverberation from
being cut off.
* The sound that is output from the MASTER OUT jacks is
exported as the audio file. Depending on the routing settings
(p. 44), specific sounds might not be exported in some cases.
6
Press the [F5] (EXECUTE) button.
A confirmation message appears.
If you decide to cancel, select "CANCEL" and press the [ENTER]
button.
7
Select "OK" and press the [ENTER] button.
The export starts.
The exported data is saved in the "EXPORT folder" (p. 40).
NOTE
Never do the following operations while export is progressing.
These operations might cause all recorded data to be lost.
5 Turning off the power
5 Removing the SD card
5 Striking a pad
MEMO
5 If exported data of the same name already exists, the
message "Overwrite it?" appears. If it is OK to overwrite the
data, select "OK" and press the [ENTER] button. If you decide
to cancel the operation, select "CANCEL" and press the
[ENTER] button; then change the name and export the data.
5 If you decide to cancel the export without completing it,
press the [F4] (ABORT) button.
5 When you export a drum performance as SMF data, the data
is exported using the note numbers specified by the drum
kit and the MIDI settings in SETUP. For details, refer to "Data
List" (PDF).
Advertisement
Table of Contents
