Maintenance - Elem Garden Technic TDTAC46HP5T-C User Manual

- Fill up with gasoline and oil before staring the engine. Never open the cap of the fuel tank to
add gasoline while the engine is running or still hot.
- Do not start the engine if there is some gasoline spread around, take the mower away from
the one where gasoline have been split and avoid any contact from a hot source as long as
the split gasoline is completely eva0porated.
- Tighten the fuel tank cap and close tightly the jerry can cap.
Maintenance and storage
- Make sure that all nuts, bolts and screws are kept well tightened to keep the lawnmower in a
safe operating condition.
- Never store the lawnmower with a tank with gasoline in an enclosed area where gasoline
fumes could reach a strong heat source or a flame. Allow the engine to cool down before you
store your lawnmower in any storage place.
- In order to reduce any risk of fire, clean the lawnmower and in particularly the engine, the
muffler, the fuel tank. Suppress all grass traces or leaves or excess of grease.
- Check frequently the condition of the deflector and the grass catcher, replace them if the are
damage.
- In case of drain oil of the tank before winter, do this operation outside.
- Wear thick gloves for the mounting and the sharpening of the blade. Be sure that the blade is
always well balance.

8-MAINTENANCE

WARING:
stop the engine and unplug the spark plug before any repairing or maintenance
operations.
:Stop the engine and unplug the spark plug before any repairing or maintenance operations.
- For four strokes engine read carefully the maintenance engine manual. Check regularly the
oil level and add some oil or replace it if necessary.
- Frequently check the lawnmower and ensure that all grass deposits are removed from
beneath the deck.
- Lubricate regularly the wheel axle and the bearings with grease.
- Check often the blade, in order to obtain a clean work the blade should always be sharp and
well balance.
WARNING: Stop the engine and unplug the
spark plug before an repairing or maintenance
operations