Table of Contents
Advertisement
Connect the cables as shown in the following illustration.
*1 60 mm (2 3/8 in) or less
R Use a straight CAT 5e (or higher) Ethernet cable (not included) that is 6.5 mm (1/4 in) in diameter or
less.
When connecting to a switching hub
R If PoE is available, an AC adaptor is not needed.
R This unit complies with the PoE Class 1 standard.
When connecting a PC
R The PC port does not support PoE for connected devices.
When connecting cables and the AC adaptor
R Pass the Ethernet cable and the AC adaptor cord under the stand.
Wall Mounting
Note
R Make sure that the wall and the fixing method are strong enough to support the weight of the unit.
1. Insert the tabs of the wall mounting adaptor into the designated openings in the base, and then slide
the wall mounting adaptor in the direction of the arrow until it clicks.
2. Fasten the wall mounting adaptor to the base with the small screw.
(Recommended torque: 0.4 N·m [4.08 kgf·cm/3.54 lbf·in] to 0.6 N·m [6.12 kgf·cm/5.31 lbf·in])
3. Connect the AC adaptor and handset cord.
*1
Installation and Setup
53
Advertisement
Table of Contents
