Table of Contents
Advertisement
Before Switching On Your TV
Power Connection
IMPORTANT: The TV set is designed to operate on
230-240V AC, 50 Hz.
• After unpacking, allow the TV set to reach the ambi-
ent room temperature before you connect the set to
the mains.
Connections To The Aerial Input Socket
• Connect the aerial or cable TV plug to the Aerial input
socket located at the rear of the TV and connect the
cable plug coming out from the TV out socket lo-
cated on the devices (VCR, DVB etc.) to this socket
as well.
75
VHF/UHF
REAR OF THE TV
Inserting Batteries In The Remote
Control Handset
WARNING : Remote control is battery included. A plas-
tic protector is used to disconnect the batteries in
order to prevent the battery life from reducing. Please
remove the plastic protector before the first use.
• Remove the battery cover located on the back of the
handset by gently pulling backwards from the indi-
cated part.
• Insert two AAA/R03 or equivalent type batteries
inside. Place the batteries in the right directions and
replace the battery cover.
CABLE TV
English - 5 -
Note: Remove the battery from remote control hand-
set when it is not to be used for a long period. Other-
wise it can be damaged due to any leakage of bat-
tery.
Switching The TV ON/OFF
To switch the TV on:
Your TV will switch on in two steps:
1- Connect the power supply cord to the system.
Press Power On/Off button.Then the TV switches
itself to stand-by mode (Optional).
2- To switch on the TV from stand-by mode either:
Press a digit button on the remote control so that a
programme number is selected, or Press the "-P/CH"
or "P/CH+" button on the TV or press the "P+" or "P-"
button on the remote control, so that last mode switched
off is selected.
By either method the TV will switch on.
To switch the TV off:
• Press the "
(stand-by)" button on the remote control
or On/Off switch on the TV, so the TV will switch to
stand-by mode.
To power down the TV completely, press Power On/Off
button or unplug the power cord from the mains socket.
Navigating the Menu System
For displaying
menu options
1- Press "M" to display the menu.
2- Press "
" or "
" button to select an icon. Press
"
" for more options.
3- Use "
" or "
" button to highlight.
4- Press "
" or "
" buttons to change the settings.
5- To exit the menu or return from sub-menu screen,
press "M".
These explanations are available for the navigation
of the whole Menu System. To select options that are
explained in the following parts, refer to "Navigating
The Menu System".
Note: Except for Install menu, other menu options will
be automatically stored when an adjustment is set.
For navigation
To confirm choices
INFO
OK
SELECT
Advertisement
Table of Contents
