Dukane ImagePro 6860WUSS User Manual page 33

Adjusting with the remote control
1. Hold the CTL button and press the ECO/L-SHIFT button.
The [LENS SHIFT] screen will be displayed.
2. Press the ▼▲◀ or ▶ button.
Use the ▼▲◀▶ buttons to move the projected image.
NOTE:
Lens Calibration
If the power of the projector is wrongly shut down during the motion of lens shift, it may shift the home position of the lens and
may cause of malfunction. In this case, perform lens calibration.
Lens calibration procedures
1. Power on the projector.
2. Press and hold the (CTL) button and press the (INFO/L-CALIB.) button on the remote control.
Calibration is performed.
TIP:
• The diagram below shows the lens shift adjustment range for the
front). To raise the projection position higher than this, use the tilt feet. (→ page 22)
• For the PX602WL-WH/PX602WL-BK and the ceiling mount/front projection lens shift adjustment range, see page 156. 6860WSS and 6860WSS-B
* 30%V for the PX602WL-WH/PX602WL-BK. 6860WSS and 6860WSS-B.
Description of symbols: V indicates vertical (height of the projected image), H indicates horizontal (width of the projected image).
15%H
10%H
50%V
20%V*
100%V
20%V*
50%V
10%H 100%H
15%H
20
2. Projecting an Image (Basic Operation)
6860WUSS and 6860WUSS-B
15%H
10%H
Width of projected image
20%V*
Height of projected image
20%V*
10%H
15%H
(projection mode: desktop