Table of Contents
Advertisement
BeFore You caLL -
ProBLeM
entire oven does not
operate
self-cleaning cycle
does not Work
soil not completely
removed after self-
cleaning cycle is
completed
Flames inside oven
or smoke from Vent
28
Solutions to Common Problems
soLution
When the oven is first plugged in, or when the power supply to the oven has been
interrupted, the display will flash. The oven cannot be programmed until the clock is set.
Be sure electrical cord is securely connected into the electrical junction box.
Cord/plug is not installed and/or connected. Cord is not supplied with oven. Contact your
dealer, installing agent or authorized servicer.
Service wiring not complete. Contact your dealer, installing agent or authorized servicer.
Power outage. Check house lights to be sure. Call your local electric company.
Short in cord/plug. Replace cord/plug.
Controls are not set properly. See instructions to set the controls.
House fuse has blown or circuit breaker has tripped immediately following installation.
House fuse may not be fully engaged. Check fuse and screw or engage circuit breaker securely.
Make sure the oven door is closed.
Make sure you have removed the oven racks and the oven rack supports from the oven.
Controls not set properly. Follow instructions under "Using the Self-Clean Feature".
Failure to clean bottom, from top of oven, frame of oven or door area outside oven seal.
These areas are not in the self-cleaning area, but get hot enough to burn on residue. Clean
these areas before the self-cleaning cycle is started. Burned on residue can be cleaned
with a stiff nylon brush and water or a nylon scrubber. Be careful not to damage the oven
gasket.
Excessive spillovers in oven. Set the self-clean cycle for longer cleaning time.
Excessive spillovers in oven. This is normal, especially for high oven temperatures, pie
spillovers or for large amounts of grease on bottom of oven. Wipe up excessive spillovers.
Advertisement
Table of Contents
