Larson Electronics EPL-HB-100LED-RT-JB2-6-EPP Instruction Manual

100W Explosion Proof High Bay LED Light Fixture
14,000 Lumens - Paint Spray Booth Approved
This explosion proof light is designed for illumination of industrial locations. It uses the latest in
solid state lighting technology for long life, low maintenance and high efficiency.
The unique design focuses the light where it is needed, giving improved efficiency over a
conventional HID luminaire.
This light fixture is shipped preconfigured to work in the selected voltage range. This includes
100-277V AC 50/60hz or 11-25V AC/DC depending on model selected. An internal, universal input
power-factor-corrected switch allows it to be used from any voltage within range without variation in
light output. Check product label for correct input voltage!
WARNING
To avoid the risk of fire, explosion or electric shock, this product should be installed, inspected
and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock:

Be certain electrical power is OFF before and during installation and maintenance.

Luminaire must be connected to a wiring system with an equipment-grounding conductor.
To avoid explosion:

Make sure the supply voltage is within the luminaires' voltage rating.

Ensure the marked T rating is less than the ignition temperature of the Hazardous
Atmosphere.

Do not operate in ambient temperatures above those indicated on the luminaire nameplate.

Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
For supply connections, use wire rated for at least 110°C
Recommended mounting height is 15-40 feet.
MOUNTING
This fixture features a surface mount trunnion style bracket that can be mounted to any flat
surface that can support the load, and where bolt holes can be drilled. This mount bracket
allows for simple angle adjustments simply by loosening the adjustment bolts on either side of
the fixture, tilting the light to the desired angle, then tightening the bolts again to hold the light in
position.
Larson Electronics, LLC
Instruction Manual
Phone: (800) 369-6671 Fax: (903) 498-3364
EPL-HB-100LED-RT-JB2-6-EPP
www.larsonelectronics.com 1 of 2