Brother ScanNCut SDX900 Setup Manual page 16

Error code
Err-03
Err-04
Err-05
Err-20
When Registering the Machine with CanvasWorkspace
Error message
A network error
occurred.
Errors occurred in
network function.
Registration failed.
Unconnected to the
internet server.
Check the proxy setting.
Unconnected to the
network.
Check the network
connection status.
14
The Authentication/Encryption methods used by the selected wireless access point/router are
not supported by your machine.
For infrastructure mode, change the authentication and encryption methods of the wireless
access point/router.
Your machine supports the following authentication methods:
Authentication method
WPA-Personal
WPA2-Personal
Open
Shared key
If your problem is not solved, the Network Name (SSID) or network settings you entered may be
incorrect. Reconfirm the wireless network settings.
See "How can I find the wireless security information (Network Name (SSID) and Network
Password)" on page 13 to confirm.
The security information (Network Name (SSID)/Network Password (Network Key)) is incorrect.
Reconfirm the Network Name (SSID) and security information (Network Password (Network
Key)).
See "How can I find the wireless security information (Network Name (SSID) and Network
Password)" on page 13 to confirm.
The wireless security information (Authentication method/Encryption method/Network
Password (Network Key)) is incorrect.
Reconfirm the wireless security information (Authentication method/Encryption method/
Network Password (Network Key)) in the table of Err-03.
See "How can I find the wireless security information (Network Name (SSID) and Network
Password)" on page 13 to confirm.
The machine is still trying to connect to your wireless network. Please wait a few minutes, and
then check the WLAN status.
A network error occurred during communication.
Check the following.
- Is your wireless access point/router turned on?
- Is the network cable of your wireless access point/router plugged in?
An internal malfunction occurred.
Contact the retailer where you purchased this machine or the nearest authorized service
center.
Registration of the PIN code failed.
Internal data may be corrupted.
Contact the retailer where you purchased this machine or the nearest authorized service
center.
The proxy settings are incorrect.
Check the proxy settings of your wireless network and your machine.
The machine is not connected to the network.
- Check that there is a good network connection.
- A network connection may not yet be established.
Wait a while, and then try again.
Cause/Solution
Encryption method
TKIP
AES
AES
WEP
None (without encryption)
WEP
Cause/Solution