Connecting Your Monitor - Iiyama ProLite T1634MC-B7X User Manual

CONNECTING YOUR MONITOR

Ensure that both the computer and the monitor are switched off .
Connect the computer to the monitor with the signal cable.
Connect the computer to the monitor with the USB Cable.
Connect the monitor cable to the Remote Control Touch V01 (option), if necessary.
Connect the AC Adapter to the monitor and the Power Cable to the AC Adapter fi rst and then
connect to the power source.
Turn on your monitor and computer.
 The signal cables used for connecting the computer and monitor may vary with the
NOTE
type of computer used. An incorrect connection may cause serious damage to both
the monitor and the computer. The cable supplied with the monitor is for a standard
connector. If a special cable is required please contact your local iiyama dealer or
regional iiyama offi ce.
 For connection to Macintosh computers, contact your local iiyama dealer or regional
iiyama offi ce for a suitable adaptor.
 Make sure you tighten the fi nger screws at each end of the Signal Cable.
 The Class I pluggable equipment Type A must be connected to protective earth.
 The socket-outlet shall be installed near the equipment and shall be easily accessible.
[Example of Connection]
Remote
Control
Touch V01
(option)
Power Cable
(Accessory)
* VGA cable is not supplied with the monitor. If you use low quality VGA cable, it may cause a result
of electro-magnetic interference. Please contact the iiyama Support Centre in your country if you
wish to connect the monitor via the VGA input.
[Collect Cables]
Put the cables through the cable holes.
Collect cables at the back of the stand.
<Back>
AC Adapter
(Accessory)
DisplayPort Cable (Accessory)
USB Cable (Accessory)
VGA Cable (Not included)*
HDMI Cable (Accessory)
AC adapter
fastening
BEFORE YOU OPERATE THE MONITOR 7
Computer
Cable Hole