Handle Installation; Camera Installation - Manfrotto MVG460 Instructions Manual

GB
User Guide
⚠
Read the detailed manual before
using this products.
TIPS
(1) Please install the camera before powering on the gimbal.
(2) When the battery is low, please charge the gimbal.
(3) When not in use, turn off the gimbal and then remove the batteries.
(4) For quick start, utilising MVG640 basic features follow the steps below.
1
Battery Installation
Remove the tail cap, open the batteries compartment, and install the batteries
correctly.
2

Handle Installation

Align the handle positioning screw with the corresponding positioning holes under the
pan axis machine and then tighten the fixing ring.
⚠
The four positioning screws must be aligned with the corresponding positioning
holes and then tighten the fixing ring.
Alignment
Alignment
⚠
Please fully charge the
batteries before powering on
the gimbal for the first time.
Tight
A. Stylus
B. Positioning hole
C. Positioning screw
Loose
3
Positioning Lock
Each of the three rotating axis has one positioning lock for convenient positioning and
storage purposes. Be sure to unlock them before using the gimbal.
4

Camera Installation

(1) Install the quick release plate to the
fixed plate and take out the secondary
quick release plate.
Secondary quick release plate
6
Balanced lock Stored lock
⚠
Make sure the battery and memory
card are loaded before installation.
(2) Fix the secondary quick release
plate to the bottom of the camera.
⚠
Please follow the direction
of the icon on the
back of the secondary
quick release plate to
install.