Preparation - Xerox WorkCentre 5632 Installation Manual

Preparation

This section explains the preparation and resources required to install the Smart Card.
The installation will take approximately one hour for each device. The following items are required in
order to complete the installation:
Compatible Card Reader (refer to
Compatible Access Card (refer to
Smart Card enablement kit 498K17544
(one for each Xerox device)
Feature Enable Key
TCP/IP enabled on the device
DNS Host name or static IP address assigned
Network Settings to be checked to ensure network is fully functional
Domain Controller (DC) information:
• Domain Controller authentication environment
• lP address or Host Name
• Domain information
• Domain Controller Root and Intermediate certificates
• Check that all certificates are in 64 bit X.509 format
• Determine if the DC is registered with the OCSP at this site
Online Certificate Status Protocol (OCSP) Server Information:
• OCSP Server URL
• OCSP - Root and Intermediate Certificates
• Check that all certificates are in 64 bit X.509 format
Proxy Server configuration details
To set up the Domain Controller (DC) validation, you will need to determine if your site validates the DC
against the Online Certificate Status Protocol (OCSP) server. Many sites use OCSP to validate
individuals, but do not register the DC with it. If you set up the Xerox device to validate the DC and it
isn't registered, the procedure will fail.
If your site does register the DC with OCSP, you will need to decide whether:
• to validate the DC against OCSP before validation of the user, or
• to validate the DC after validation of the user
Item
Supported Card Types on page 7)
Supported Card Types on page 7)
2
Supplier
Customer
Customer
Xerox
Xerox
Customer
Customer
Customer
Customer
Customer
Customer
Xerox® Smart Card
Installation Guide
9