Table of Contents
Advertisement
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 19.
3. Remove the front bezel. See "Replacing the front bezel" on page 20.
4. Pivot the drive bay assembly upward. See "Pivoting the drive bay assembly upward and downward" on
page 23.
5. Disconnect the heat sink and fan assembly cable from the system board.
6. Replace the heat sink and fan assembly.
Figure 64. Removing the heat sink and fan assembly
Figure 65. Installing the heat sink and fan assembly
7. Connect the new heat sink and fan assembly cable to the system board.
42
M920s User Guide and Hardware Maintenance Manual
Advertisement
Table of Contents
