Table of Contents
Advertisement
Figure 22. Installing the optical drive retainer
Figure 23. Installing the optical drive
6. Connect the signal cable and the power cable to the new optical drive.
7. Reinstall the removed parts. To complete the replacement, see "Completing the parts replacement" on
page 62.
Pivoting the drive bay assembly upward and downward
Attention: Do not open your computer or attempt any repairs before reading the Important Product
Information Guide.
1. Remove any media from the drives and turn off all connected devices and the computer. Disconnect all
power cords from electrical outlets and disconnect all cables from the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 19.
3. Remove the front bezel. See "Replacing the front bezel" on page 20.
4. Pivot the drive bay assembly upward and downward.
.
Chapter 4
Replacing hardware
23
Advertisement
Table of Contents
