Integrated Peripherals - Gigabyte 8S648-RZ User Manual

CPU Hyper-Threading
Enabled Enables CPU Hyper Threading Feature. Please note that this feature is only working
for operating system with multi processors mode supported. (Default value)
Disabled Disables CPU Hyper Threading.
Init Display First
Select the first initation of m onitor or display from AGP or PCI VGA card.
AGP Set Init display first to AGP. (Default value)
PCI Set Init display first to PCI.

Integrated Peripherals

CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
IDE1 Conductor Cable
IDE2 Conductor Cable
On-Chip Primary PCI IDE
On-Chip Secondary PCI IDE
AC97 Audio
Onboard LAN device
*
USB Controller
USB Legacy Support
Onboard Serial Port 1
Onboard Serial Port 2
Onboard Parallel Port
Parallel Port Mode
x ECP Mode Use DMA
Game Port Address
Midi Port Address
Midi Port IRQ
higf : Move
Enter: Select
F5: Previous Values
IDE1 Conductor Cable
Auto Will be automatically detected by BIOS. (Default value)
ATA66/100 Set IDE1 Conductor Cable to ATA66/100 (Please make sure your IDE device
and cable is com patible with ATA66/100).
ATA33 Set IDE1 Conductor Cable to ATA33 (Please make sure your IDE device and
cable is compatible with ATA33).
IDE2 Conductor Cable
Auto Will be automatically detected by BIOS. (Default value)
ATA66/100 Set IDE2 Conductor Cable to ATA66/100 (Please make sure your IDE device
and cable is com patible with ATA66/100).
ATA33 Set IDE2 Conductor Cable to ATA33 (Please make sure your IDE device and
cable is compatible with ATA33).
On-Chip Primary PCI IDE
Enabled Enable onboard 1st channel IDE port. (Default value)
Disabled Disable onboard 1st channel IDE port.
On-Chip Secondary PCI IDE
Enabled Enable onboard 2nd channel IDE port. (Default value)
Disabled Disable onboard 2nd channel IDE port.
"*" Only for 8S648-RZ.
8S648-RZ Series Motherboard
Integrated Peripherals
[Auto]
[Auto]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[3F8/IRQ4]
[2F8/IRQ3]
[378/IRQ7]
[SPP]
3
[201]
[330]
[10]
+/-/PU/PD: Value F10: Save
F6: Fail-Save Default
- 24 -
Item Help
Menu Level}
[Auto]
Auto-detect IDE
cable type
[ATA66/100/133]
Set Conductor cable
to ATA66/100/133(80
-pins)
[ATA33]
Set Conductor cable
to ATA33(40-pins)
ESC: Exit F1: General Help
F7: Optimized Defaults