Cutting Tips - SNOWJOE SUNJOE SWJ801E-RM Operator's Manual

Fig. 13
Safety lock button
Trigger
switch
5. To turn the tool OFF, release the trigger switch (Fig. 13).
NOTE: Do not press the trigger switch until you are ready
to make a cut.
Adjusting the Telescoping Pole
1. Disconnect the saw from the power supply.
2. Unclip the telescoping cam-lock to release the pole
(Fig. 14).
Fig. 14
3. Extend the pole to the desired length (Fig. 15).
NOTE: Push poles toward each other to shorten the pole
or pull them away from each other to lengthen the pole.
Only extend the pole to the minimum length required to
reach the limb to be cut.
Fig. 15
Telescopic pole
Cord
restraint
Telescoping
cam-lock
11
4. Lock the pole in position by closing the cam-lock (Fig. 16),
and ensure that the pole is secure. If the pole telescopes
when the cam-lock is closed, the nut may need tightening.
Fig. 16
Cam-lock
m
WARNING!
Failure to lock the telescopic pole cam-lock
as directed could result in personal injury.

Cutting Tips

Proper Cutting Stance
• Balance your weight with both feet on solid ground.
• Your body should always be to the left of the chain line.
• The most typical cutting application is to position the
unit at an angle of 60° or less depending on the specific
situation (Fig. 17). As the angle of the pole chain saw shaft
to the ground increases, the difficulty of making the first
cut (from the underside of the limb) increases.
Fig. 17
60º MAXIMUM