Spread Spectrum Modulated - Gigabyte 7VT600-RZ User Manual

F

Spread Spectrum Modulated

8Disabled
8Enabled
F
CPU Host Clock Control
Note: If system hangs up before enter CMOS setup utility, wait for 20 sec for times out reboot . When
tim e out occur, system will reset and run at CPU default Host clock at next boot.
8Disable
8Enable
F
CPU Host Frequency (MHz) (By switch SW1)
8100
8133
8166
8200
FPCI/AGP Frequency (MHz)
8The values depend on CPU Host Frequency(Mhz) .
F
DRAM Clock (MHz)
8Please set DRAM Clock according to your requirement. (Default value: Auto)
If you use DDR266 DRAM module, please set "DRAM Clock(MHz)" to "133-DDR266". If you use
DDR333 DRAM module, please set "DRAM Clock(MHz)" to "166-DDR333". If you use DDR400
DRAM module, please set "DRAM Clock(MHz)" to "200-DDR400".
Incorrect using it may cause your system broken. For power End-User use only!
F
CPU OverVoltage Control
Increase CPU voltage m ay get stable for Over_Clock. But it may damage to CPU when enable this
feature.
8Auto
8+5% / +7.5% / +10% Increase voltage range as user selected.
F
AGP OverVoltage Control
Increase AGP voltage may get stable for Over_Clock. But it may damage to AGP Card when enable this
feature.
8Auto
8+0.1V ~ +0.3V
F
DIMM OverVoltage Control
Increase DRAM voltage may get stable for Over_Clock. But it may dam age to DRAM m odule when
enable this feature.
8Auto
8+0.1V ~ +0.3V
Disable clock spread spectrum.
Enable clock spread spectrum.(Default value)
Disable CPU Host Clock Control.(Default value)
Enable CPU Host Clock Control.
Set CPU Host Clock to 100MHz~132M Hz.
Set CPU Host Clock to 133MHz~165M Hz.
Set CPU Host Clock to 166MHz~200M Hz.
Set CPU Host Clock to 200MHz~254M Hz.
Supply voltage as CPU reguired. (Default value)
Supply voltage as AGP Card reguired. (Default value)
Set AGP voltage from 1.6V~1.8V.
Supply voltage as DRAM module reguired. (Default value)
Set DIMM voltage from 2.6V~2.8V.
- 33 - BIOS Setup