GarageAce ET30 Instruction Manual page 8

PLEASE NOTE：
THE INSTRUCTIONS FOR FIXING THE OPERATOR TO THE DOOR ARE FOR
RIGHT HAND INSTALLATIONS ONLY.
Installation process (FIG. 3, FIG. 4, and FIG. 5)
1. Check that the door shaft U bolt is securely tightened on
the left hand side of the door.
2. Raise the door and tie a rope around the center to
secure the roll.
3. Support the right hand end of the door with a suitable
prop, e.g. step ladder and soft padding to protect door
surface.
WARNING：DO NOT ALLOW CHILDREN/PERSONS
AROUND THE DOOR AND PROP. SERIOUS PERSONAL
INJURY AND/OR PROPERTY DAMAGE CAN RESULT FROM
FAILURE TO FOLLOW THIS WARNING
4. Carefully loosen and remove the right hand door shaft
U-bolt.
5. Make sure that the door supporting prop is secure. While
the door is supported remove the right hand door
mounting bracket from wall.
6. Remove the drive assembly from the packaging. Try to
rotate the drive gear by pushing on the fork (Fig. 6). If the
gear does not rotate the manual mode has to be
selected. To select pull downward the manual release
lever. The drive gear should now rotate freely.
7. Slide the drive assembly over the door axle making sure
that the fork extends into and over one of the spokes of
the door drum wheel.
8. Refit the door mounting bracket to the wall. In some
cases the bracket may have to be re-positioned. Re-fit
and tighten the door shaft U-bolt. Remove door
supporting prop and untie the rope from the curtain.
9. Straighten the drive assembly and position as per Fig. 5.
Tighten the two locking bolts firmly to secure the
operator.
10. Check the manual operation of the door by raising and
lowering the door. The door should run
smoothly.
NOTE: After installation, ensure that parts do not extend
over public footpaths or roads．
8