Installation Instructions - Pages - GarageAce ET30 Instruction Manual

3. Installation instructions
IMPORTANT SAFETY INSTRUCTIONS FOR
INSTALLATION
Warning：Incorrect installation can lead to severe
injury. Follow this installation instruction.
SIDE ROOM REQUIREMENTS
Fig. 1 shows the minimum and recommended side
room. The distance between the edge of the door
curtain and the inside of the bracket must be at least
40mm. However, for easier access it is
recommended that at least 95mm is allowed．
1. CHECK OPERATION OF DOOR
BEFORE BEGINNING THE INSTALLATION CHECK THE OPERATION OF THE DOOR
The door must be well balanced and be in a reasonable operating condition. The ideal operational effort in
raising or lowering the door should not exceed a force of l0kg (22 lbs．)．Make sure that all door locks, ropes,
chains etc. are neither released, nor disabled and remove unnecessary accessories．
2. FIX
2. FIXING OF DOOR WEIGHT BAR (OPTIONAL)*
*Optional extra – not required for majority of
installations
Move the door manually to the mid open position.
Place the weight bar on the bottom rail, in the middle
of the door and secure with the fasteners provided
(FIG. 2). Check the operation of the door again. If the
door feels heavy it may require extra tension to be
added to the door springs ． Refer to the door
Installation manual from the manufacturer on how to
tension the door.
3. INSTALLING OPERATOR
The ET-30 roller door operator can be fixed to the roll up garage door in a variety of ways. Described below is
one method of fixing. Make sure there is enough side room to slide the drive assembly onto shaft.
7