Table of Contents
Advertisement
Introduction
Always consult your local Building Department regarding regula-
tions, codes or ordinances which apply to the installation of a vent-
ed decorative gas log set in a solid-fuel burning fireplace.
This appliance is only for use with the type of gas indicated on the
rating plate.
Instructions to Installer
1.
Installer must leave instruction manual with owner after instal-
lation.
2.
Installer must have owner fill out and mail warranty card sup-
plied with the fireplace.
3.
Installer should show owner how to start and operate the fire-
place.
Any change to this appliance or its controls can be dangerous.
Improper installation or use of the appliance can cause serious
injury or death from fire, burns, explosion or carbon monoxide
poisoning.
General Information
Any alteration of the original design, installed other than as
shown in these instructions or use with a type of gas not
shown on the rating plate is the responsibility of the person
and company making the change.
• Remove all contents from the burner carton.
• Check the contents of the carton against the parts list in this
manual. Report any missing or damaged parts to your dealer.
• Turn off gas supply to fireplace or firebox.
• Have the fireplace floor and chimney professionally cleaned to
remove ashes, soot, creosote or other obstructions.
Have this cleaning performed annually after installation.
• Seal any fresh air vents or ash clean-out doors located on floor
or wall of fireplace. If not, drafting may cause pilot outage or
excessive sooting. Use a heat-resistant sealant. Do not seal
chimney flue damper.
Installing Damper Clamp
Remove all ashes or other debris from the fireplace. If the fireplace
is equipped with an ash dump be sure to seal the door with furnace
cement or high temperature silicone. Be sure to check the damper
for proper operation and verify that the flue passageway is open.
Attach damper clamp to the vent damper and tighten hold down bolt.
Place the clamp over the lip of the damper and tighten the hold
down bolt until the clamp is securely attached to the damper. This
will prevent the damper from accidentally closing.
Page 10
INTRODUCTION
WARNING
FIREPLACE PREPARATION
Important
All correspondence should refer to complete Model No., Serial No.
and type of gas. This information can be found on the data plate
supplied with the burner.
NOTICE: During initial use of the logs you will detect an odor as
the logs are cured. This is normal.
A fireplace screen must be in place when this appliance is
in operation. The screen shall allow for introduction of com-
bustion air.
When this decorative gas appliance is used in a fireplace
equipped with glass doors, the glass doors should remain
open during log set operation. This will maximize the radiant
heat provided to the surrounding area, and minimize over-
heating of any valve installation. The glass doors may be
closed when the log set is not in use.
DAMPER
CLAMP
DAMPER
WARNING
WARNING
TYPICAL FIREPLACE
Figure 2
40916-0-0919
Advertisement
Table of Contents
