Tools Needed - RIDGID R4021SN Operator's Manual

FEATURES
KNOW YOUR TILE SAW
See Figure 4.
The safe use of this product requires an understanding of
the information on the tool and in this operator's manual as
well as a knowledge of the project you are attempting. Before
use of this product, familiarize yourself with all operating
features and safety rules.
7 in. TILE CUTTING WHEEL - A 7 in. tile cutting wheel is
included with your saw.
WARNING:
Do not use wheels rated less than the speed of
this tool. Failure to heed this warning could result
in personal injury.
BEVEL TABLE - Beveled 22.5° and 45° cuts can be made
using the bevel table.

TOOLS NEEDED

The following tool (not included or drawn to scale) are needed for assembly and alignment:
PHILLIPS SCREWDRIVER
13 MM WRENCHES OR
ADJUSTABLE WRENCHES
10 — English
MITER GUIDE - The easy-to-read indicator on the miter
guide shows the exact angle for the desired cut.
MOTOR - This machine has a strong motor with sufficient
power to handle tough cutting jobs.
ON/OFF SWITCH - This saw has an easy access on/off
switch located below the front rail.
REAR SUPPORT TABLE - Helps in supporting larger tiles
up to 24 in. when making rip cuts.
RIP GUIDE - Rip guide is fully adjustable for making cross
cuts and using the miter guide.
SPLASH HOOD - The splash hood helps contain overspray
and mist.
TILE SAW STAND - This saw comes with a stand for in-
creased portability and convenience.
WRENCH STORAGE - The wheel wrench and arbor wrench
may be stored on the side of the tool and secured with a
wing nut.
2 MM HEX KEY,
3 MM HEX KEY
Fig. 5