Ethernet And Audio Board - Dell G15 5525 Service Manual

Steps
1. Align the screw holes on the USB board with the screw holes on the system board and insert the USB board in to the system
board.
2. Replace the two screws (M2x4) that secure the USB board to the system board.
Next steps
1. Install the system board.
2. Install the memory module.
3. Install the wireless card.
4. Install the solid-state
5. Install the rear cover.
6. Install the battery.
7. Install the base cover.
8. Follow the procedure in

Ethernet and audio board

Removing the Installing the Ethernet and audio board
Prerequisites
About this task
The following image indicates the location of the ethernet and audio board and provides a visual representation of the removal
procedure.
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
4. Remove the rear cover.
5. Remove the solid-state
6. Remove the wireless card.
drive.
After working inside your
Before working inside your
drive.
computer.
computer.
Removing and installing components 45