Dell G15 5525 Service Manual page 20

3. Place the thermal shield on the solid-state drive.
4. Align the screw holes on the thermal shield with the screw holes on the solid-state drive and system board.
5. Replace the two screws (M2x4) that secure the thermal shield to the solid-state drive and the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in
Procedure to move the solid-state drive holder
About this task
This computer supports two solid-state drive form factors:
● M.2 2230
● M.2 2280
If you are replacing the solid-state drive of a different form factor other than the one removed, see the following procedure to
move the location of the solid-state drive holder.
Steps
1. Remove the solid-state drive holder from the palm-rest and keyboard assembly.
2. Turn the solid-state drive holder to 180 degrees.
3. Insert the solid-state drive holder into the other solid-state drive holder slot on the palm-rest and keyboard assembly.
4. To install 2230 solid-state drive, see
5. To install 2280 solid-state drive, see
20 Removing and installing components
After working inside your
installing 2230 solid-state
installing 2280 solid-state
computer.
drive.
drive.