Table of Contents
Advertisement
About this task
The following image indicates the location of the USB board and provides a visual representation of the installation procedure.
Steps
1. Slide the USB board into the M.2 card slot on the system board and align the screw holes on the USB board to the screw
holes on the system board.
2. Replace the two screws (M2x4) that secure the USB board to the system board.
3. Turn the system-board assembly over.
Next steps
1. Install the
system
board.
2. Install the
memory
modules.
3. Install the
wireless
card.
4. Install the
solid-state
5. Install the
rear
cover.
6. Install the battery.
7. Install the
base
cover.
8. Follow the procedure in
Ethernet and audio board
Removing the ethernet and audio board
Prerequisites
About this task
The following image indicates the location of the ethernet and audio board and provides a visual representation of the removal
procedure.
1. Follow the procedure in
2. Remove the
base
cover.
drive.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs)
69
Advertisement
Table of Contents
