Ethernet And Audio Board; Removing The Ethernet And Audio Board - Dell NOT22357 Owner's Manual

Steps
1. Slide the USB board into the M.2 card slot on the system board and align the screw holes on the USB board to the screw
holes on the system board.
2. Replace the two screws (M2x4) that secure the USB board to the system board.
3. Turn the system-board assembly over.
Next steps
1. Install the system board.
2. Install the memory modules.
3. Install the wireless card.
4. Install the solid-state
5. Install the rear cover.
6. Install the battery.
7. Install the base cover.
8. Follow the procedure in

Ethernet and audio board

Removing the ethernet and audio board

Prerequisites
About this task
The following image indicates the location of the ethernet and audio board and provides a visual representation of the removal
procedure.
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
4. Remove the rear cover.
drive.
After working inside your
Before working inside your
computer.
computer.
Removing and installing Field Replaceable Units (FRUs) 69