Table of Contents
Advertisement
COLLATE JOBS
After you have inserted or appended the entries, adjust the set-
tings for the jobs and individual entries in the job editor. To do
this, read the following chapter.
Entry information
Before you can begin with a possible change to the settings, you
can view a summary of all the currently loaded settings.
Click on the white "i" for information display in the "View" tool-
bar:
For most file formats you can only see the "Misc" tab. It contains
e.g. the information about the file format, the drawing size and
used pens. If you open a HPGL- or Calcomp drawing, you can
read on this tab information about general settings ("Pen
Source", "Pen Scale", "Pattern Style" etc.) which you can change
in the job editor.
The tabs "Drawing" and "Pens" appear only, if you open an
HPGL- or a Calcomp drawing file. On the tab "drawing" you get
the information about the file format, the drawing size, the used
colors etc.. The tab "Pens" informs you of the pen settings. There
can also be two symbols which inform you of the setting status:
The red exclamation marks point out that the pen is used with
several pen sizes and only the last set pen size can be shown.
The green check shows, that a pen is used for the current draw-
ing.
66
RW-470 CLIENTS
Advertisement
Table of Contents
